You've spotted the crack. Whatever brought you here, the damage on your Calgary home almost certainly started with our climate, and it almost certainly doesn't need a full re-stucco. Owner-operator Agim Ajdini personally inspects, quotes, and repairs every project.
Two decades of texture matches, crack seals, and full elevation recoats. Click any photo to view full size.
Click any photo to enlarge Swipe to scroll · tap to enlarge
Before you assume the worst, here's what we diagnose on roughly 80% of calls:
Thin lines (under 1 mm wide) radiating from window and door corners. These result from normal building movement and rarely signal structural failure. A proper crack seal and texture blend eliminates them in a single visit.
Sections where the finish lifts away from the base coat or substrate. Moisture trapped behind the finish drives this separation. Caught early, we remove only the affected area and re-float new material over a sound base.
Impact damage from hail, ladders, or debris knocks loose pieces off. The exposed substrate absorbs water fast, so these need prompt attention. Repairs typically take 2–4 hours per affected zone.
Usually a drainage issue, not a stucco failure. We trace the moisture source, correct the path, and restore the finish.
Bottom line: most damage we encounter doesn't require a full re-stucco. We'll tell you exactly what category your situation falls into during a free site visit.
Calgary's Chinook winds create freeze-thaw cycles that most other Canadian cities never experience. A January afternoon can swing from −20°C to +12°C within hours. That rapid thermal cycling stresses every rigid cladding material, stucco included.
Chinook thaw pushes water into hairline cracks and unsealed joints.
Overnight temperatures drop back below freezing.
Water expands ~9% as it freezes, widening the gap.
Next thaw drives more water deeper into the wider crack.
After 3–5 cycles, delamination begins and chunks separate.
This isn't a homeowner maintenance failure. It's physics. Our crew works across the entire Calgary metropolitan area, including Airdrie, Chestermere, Cochrane, Okotoks, and Strathmore, and we see the same climate-driven patterns in every direction.
Knowing what happens during a repair removes the guesswork. Here's our standard process for a localized stucco repair.
We score around the damaged zone with a diamond blade, removing all compromised material back to a sound substrate. No shortcuts: loose material left behind guarantees a callback.
We check the wire lath, building paper, or foam board underneath. If moisture reached the sheathing, we document and address water damage before re-coating.
Where the substrate requires protection, we apply Henry's Blue Skin self-adhered membrane to seal the moisture path permanently.
We trowel a scratch coat, allow it to set, then apply the brown coat to bring the repair area flush with the surrounding wall.
We float a fresh acrylic finish (or conventional cementitious finish, depending on your existing system), replicating the original texture pattern so the patch blends seamlessly.
Using tinted finish material matched to your existing wall colour, we ensure the repair disappears once cured. Full acrylic cure takes approximately 7–14 days.
Book a free site visit and we'll show you exactly what's happening on your wall.
Homeowners tell us their biggest fear isn't the cost. It's getting told they need a $15,000 recoat when a $1,200 repair would solve the problem. We hear this on nearly every first call.
We gain nothing by recommending more work than necessary. A satisfied repair client calls us back for future maintenance and refers neighbours. That repeat relationship matters more to a small owner-operator company than one inflated invoice.
A visible patch defeats the purpose of a professional repair. We approach matching as a two-part problem.
Agim keeps a library of texture samples from Calgary's most common finish styles: sand float, dash, lace, and knockdown patterns. During the site visit, we photograph your existing texture at multiple angles and match the trowel technique, aggregate size, and application pressure on a test board before touching your wall.
Acrylic finishes fade over time under UV exposure. Matching to the original colour code often produces a result that looks too bright against a weathered wall. We blend custom tint ratios to match the current weathered shade, not the original spec, so nobody can spot the repair boundary, even standing 1 metre from the wall.
Calgary's housing stock spans multiple stucco systems installed across five decades of building. We repair and install every major system you'll find in the region.
The dominant system on Calgary homes built after 2000. Flexible, colourfast, and repairable when damaged. We apply and repair acrylic floated finishes daily.
A three-coat cementitious system common on pre-1990s homes. Heavier and more rigid than acrylic, it cracks differently and requires lime-based patching for a lasting repair.
Exterior Insulation and Finish System: rigid foam, reinforcing mesh, and a thin acrylic finish coat. Repairs demand precision; we follow manufacturer protocols on every EIFS job.
A spray-and-knock application using IMASCO products, popular on Calgary homes from the 1980s and 1990s. Matching the stipple pattern is hand-technique work we replicate cleanly.
A reinforced coating that resists woodpecker damage, a growing concern in mature-tree neighbourhoods. We install GrapheX as prevention and repair existing damage.
Single-family homes, townhouse complexes, or commercial buildings, all handled with the same crew and the same standards.
Chances are your situation matches one of these. We photograph and document every job, so ask us for photo evidence of completed repairs matching your scenario.
Solar heat drives expansion and corner stress points crack first. We route, seal, and re-texture in a single morning.
Impact from vehicles, salt spray, and snow-blower debris chew up stucco around garage openings. We cut back to sound material and rebuild the surround.
Calgary's June and July hailstorms leave pockmarks and fractured finish coats. We work with your insurance adjuster and document every affected area.
When soil or mulch sits against stucco, moisture wicks upward and the finish erodes. We repair the stucco and recommend a 200 mm minimum clearance.
Northern flickers drill through EIFS and acrylic finishes to nest. We patch the substrate, seal the cavity, and offer GrapheX Coat to prevent recurrence.
Honest ranges. Every repair varies based on area size, system type, and substrate condition. These reflect 2024 pricing for the Calgary metropolitan area.
| Scope | Range (CAD) |
|---|---|
| Small crack repairs (1–3 cracks, single wall) | $400 – $800 |
| Localized patch repairs (under 2 m²) | $800 – $1,500 |
| Multi-area repairs (3–5 zones, multiple walls) | $1,500 – $3,500 |
| Full wall recoat (single elevation) | $3,500 – $7,000+ |
| EIFS repairs (incl. insulation board replacement) | $1,200 – $4,000 |
We provide a written quote after every site visit. No ballpark numbers over the phone. We need to see the wall to give you a figure we'll stand behind.
Agim Ajdini founded Stucco Experts Ltd. in 2008 and has worked on-site on every single project since: over 18 years of Calgary stucco work. This isn't a company where a sales rep quotes the job and a different crew shows up Monday morning.
Agim inspects, quotes, manages, and works alongside the same crew from first visit to final walkthrough. The person who identified the problem is the person who verifies the repair meets standard.
Stucco Experts Ltd. carries full liability insurance and WCB coverage for every worker on your property.
Verified reviews from real clients across Calgary and surrounding areas.
"I hired Stucco Experts to do the foundation on my house and the garage. They were very responsive to coming out and doing an estimate. They came on time to start the job, were very efficient, professional and did a fantastic job! They cleaned up after they were complete. Very happy with the results! I would highly recommend them!"
"Agim and his team are such professionals! They do amazing, high quality work and provide very good service. Very easygoing, and very good prices as well. We were very happy with the outcome of our stucco. It looks beautiful! Highly recommend!!"
"Agim was recommended for our stucco patching after window installation. He was meticulous and it is apparent he takes great pride in his work. He answered all of our questions, and took the time to explain what he was doing. We found Agim's pricing to be very reasonable, and his efforts to be available when needed were greatly appreciated. Our stucco looks great, and we are extremely happy we went with Stucco Experts. We wouldn't hesitate to book again in the future, and highly recommend this company for stucco work!"
"It was a small job, but they came in a timely fashion and fixed the problem quickly. And they did a great job too! Highly recommended. Would use them again."
"Agim was professional. He did a great job on the stucco repair and painting."
"Really happy with Agim's service, he is meticulous and kind. We definitely recommend him."
Reaching out takes about 90 seconds. Here's what happens next.
Text, email, or upload a photo of the damage. Include the address and a brief description.
Agim reviews the photo and schedules a free site visit, typically within 3–5 business days.
Agim examines the damage in person, checks the substrate, and explains exactly what needs repair.
You receive a detailed quote within 48 hours of the visit, with line items for materials, labour, and timeline.
Once approved, most repairs are scheduled within 1–3 weeks and completed in 1–2 days.
We service the entire Calgary metropolitan area plus surrounding communities: Airdrie, Chestermere, Cochrane, Okotoks, Strathmore, Crossfield, Beiseker, Black Diamond, Turner Valley, High River, Langdon, and Bragg Creek.
Call or text Agim directly at 403 671 9474 for your free site visit.
